RHP MSF40 Flanged Housing Unit - 40 mm ID, 136.5 mm OD, 49.23 mm Width IKO The ball on the long

The ball on the long arm allows safe working on TORX® screws even in difficult installation positions

Temperature mode pre-set at 110 °C (230 °F)

and threaded sleeve with smooth bore are fully operational in combination with the puller device and can be used in many ways

The TX angle screwdrivers in the set of series 212 are used for operating hard-to-reach screw heads in workshops

Warranty voided if used for any other purposes

RHP MSF40 Flanged Housing Unit - 40 mm ID, 136.5 mm OD, 49.23 mm Width IKO The ball on the longFlanged Housing Unit RHP flanged housing units consist of an insert bearing pre mounted in a flanged housing for bolt on shaft support against a vertical surface. Available with two , three , and four bolt flanges in cast iron, stainless steel, and thermoplastic.